TM 9-4540-202-12&P
4-8. FUEL TANK - CONTINUED
e.
Reassembly.
(1)
Refer to Figure 4-3. If necessary, install identification plate (16) and caution plate (1 6A).
(2)
Install gasket (1 5A) by stretching it over vent cap (15).
(3)
Tighten vent cap (15).
(4)
Install gasket (13), ring (12), sash chain (11), and retainer (10) on heater body.
(5)
Install filler plug (14).
(6)
Install valve stem (4) and gasket (5) on valve body (6). Install hex nut (3) on valve body (6) and tighten.
(7)
Install nipple (8) in fuel tank
(8)
Install elbow (7) on nipple (8).
(9)
Install fuel valve assembly (2) in elbow (7).
(10)
Position fuel tank on square stud on the heater body.
4-9. BURNER
a.
Removal.
Refer to Figure 4-3. Remove burner (24) by lifting it out of the heater body.
b.
Cleaning.
(1)
Clean with a stiff bristle brush.
(2)
Remove carbon, grit, rust or other foreign matter from the holes of the burner plate.
c.
Inspection.
(1)
Inspect for excessive rust or corrosion.
(2)
Inspect for damage such as distortion, cracks or breaks. Replace as required.
d.
Installation.
Replace burner in heater body.
4-14
