T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
FRAME 23
Install Circuit Card Assembly:
CAUTION
Touching card assembly components can damage
components. Hold card assembly by edges at all times. Do
not flex or twist card assembly.
NOTE
Use this task to install any of ten card assemblies. Card
A2 (1) is shown.
1.
Put card assembly (1) in slot (2). Make sure that two ejectors (3) are out.
2. Push down on card assembly (1) until it is seated.
3. Push down two ejectors (3) to lock card assembly (1) in place.
Follow-on Maintenance:
1. Install electrical card holder, refer to task 20.
2. Install thermal system test controller; refer to para. 2-5, task 8.
3. Install thermal system test controller-case cover; refer to volume 1, para. 4-18.
TASK 19 ENDS HERE
Volume IV
2-158
Para. 2-7, Task 19
