T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
FRAME 4
Remove Electrical Contact:
NOTE
Use this task to repair receptacle connector body A5J1,
A5J2, or A5J3. Connector A5J3 (1) is shown.
Repair of connector (1) is done by replacing bad
contacts (2).
Read paragraph 2-4 on tagging wires before doing any
work.
1. Take bad contact (2) out of connector (1) with removal tool.
2. Cut off bad contact (2) with pliers Get rid of bad contact (2).
Install Contact:
3. Strip wire (3) with wire stripper.
4. Crimp new contact (2) on wire (3) with crimp tool.
5. Push new contact (2) into connector (1) until snap is heard and contact (2) is locked
in place.
6.
Repeat steps 1 through 5 as needed to repair connector.
Follow-on Maintenance:
NOTE: To install connector A5J1, A5J2, or A5J3, refer to task 14.
TASK 4 ENDS HERE
Volume IV
Para. 2-11, Task 4
2-287
