Cleaning solvents are flammable and toxic to eye, skin, and respiratory
tract. Skin and eye protections are required when working in contact with
cleaning solvents. Avoid repeated or prolonged contact. Work in well
ventilated area only. Keep away from heat, sparks, and open flame. Do not
smoke while using cleaning solvent. Failure to observe this warning can
result in injury or death to personnel.
Clean components with cleaning solvent and a clean rag. Allow to air dry.
Inspect governor control components for damage. Replace any part that is damaged in any way.
1. Install screw (13) onto manual control handle (6). Mate handle to regulator bracket assembly (3) and
install screw (9), knob (10), nut (11), and spring (12).
2. Mate regulator bracket assembly (3) to cylinder block and install screw (8). Connect springs (4, 5) to
handle (6) and lever (7). Ensure that spring (5) is connected to control handle (6) and governor lever
(7) exactly as shown. One end of spring installs in second hole from left on governor lever (7) and
opposite end of spring installs in first hole on control handle (6).
3. Install screw (1) and washer (2).