TM 10-4500-200-13
INTRODUCTION
GENERAL
Section I.
user is encouraged. Reports should be submitted on DA
Scope
Form 2028 (Recommended Changes to Publications) and
a. This manual contains instructions for the use of
forwarded direct to Commander, US Army Aviation and
personnel to whom the heaters are issued. Individual
Troop Command, ATTN: AMSAT-I-MTS, 4300 Goodfel-
models are described in separate chapters. Each chapter
low Blvd., St. Louis, MO 63120-1798.
.
contains instructions for the use of operator and organiza-
tional personnel operating and maintaining the heaters as
allocated by the maintenance allocation chart. A repair
parts list applicable to the individual model heater is pro-
a. DA Form 2258 (Depreservation Guide for Vehicles
vided in the chapter pertinent to that heater.
and Equipment).
b. Report all equipment improvement recommenda-
tions as prescribed by DA Pam 738-750.
b. For other record and report forms applicable to
operator, crew, and organizational maintenance, refer to
c. The reporting of errors, omissions, and recommen-
DA Pam 738-750.
dations for improving this publication by the individual
REPAIR PARTS
Section II
Explanation
Code
Scope
P
Applied to repair parts which are stocked in or
This section consists of an explanatory introduction for the
supplied from DSA/GSA or the Army supply system,
tabular lists and illustrations of repair parts required to
and authorized for use at indicated maintenance cate-
operate and maintain the individual dual model heater. The
gories.
explanatory introduction is applicable to each tabular
M
Applied to repair parts which are not procured or
listing in the respective chapters.
stocked but are to be manufactured at the indicated
maintenance levels.
1-4.
General
A
Applied to assemblies which are not procured or
stocked as such, but are made up of two or more units,
a. The repair parts list is arranged as follows:
each of which carries an individual stock number and
description and is procured and stocked separately
(1) Individual parts and major assemblies are
and can be assembled by units at the indicated main-
listed alphabetically by item name.
tenance categories.
X
Applied to parts and assemblies which are not
(2) Assembly components and subassemblies are
procured or stocked, the mortality of which is
listed alphabetically by item name under major assemblies.
normally below that of the applicable end item or
component, and the failure of which should result in
b. This repair parts and special tools list is divided into
retirement of the end item from the supply system.
the following tabular listings.
Xl
Applied to repair parts which are not procured or
(1) The first tabular listing following the narrative
stocked, the requirement for which will be filled by
portion of a chapter contains a list ofrepairparts authorized
use of the next higher assembly or component.
for the performance level of maintenance at the organizational
X2
Applied to repair parts which are not stocked. The
level.
indicated maintenance category requiring such
repair parts will attempt to obtain them through
(2) Repair parts authorized for the performance of
cannibalization if not obtainable through cannibal-
maintenance at the direct support level are in a listing fol-
ization, such repair parts will be requisitioned with
lowing the Repair Parts for organizational level.
supporting justification through normal supply
channels.
1-5. Explanation of Columns
Applied to major assemblies that are procured with
G
The following provides an explanation of columns in the
PEMA (Procurement Equipment Missiles Army)
tabular lists.
funds for initial issue only, to be used as exchange
assemblies at the DSU maintenance level. These
a. Source, Maintenance, and Recoverability Codes
assemblies will not be stocked above the DSU level
(SMR).
or returned to the depot supply level.
(2) Maintenance Code. This code indicates the
(1) S o u r c e C o d e . T h i s c o l u m n i n d i c a t e s t h e
lowest level of maintenance authorized to install the listed
selection status and source for the listed item. S-codes
item. The maintenance level codes are:
used are:
