TM 10-4520-262-12&P 0006 00
0006 00-6
When the blower fans stop at the end of the post-purge mode, remove fuel can (1) from fuel can stand
(2).
Loosen and remove the fuel can adapter (3) and place it on the absorbent mat (4).
Make sure all components of the fuel system are clean and free of dirt and damage that could
contaminate the fuel supply or cause leakage.
If the expected ambient temperatures do not require a fuel change, fill the fuel can with the same fuel
selected previously. Refer Table 3 of WP 0001 for fuel selection information. If the expected ambient
temperatures require a fuel change, refer to the section of this work package entitled “Refueling with a
Different Fuel”.
Install fuel can adapter (3) onto fuel can (1). Tighten securely.
Place fuel can onto fuel can stand assembly (2) and strap in place in accordance with tag attached to
stand assembly or procedures outlined in WP 0005 entitled “Assemble the Fuel Can Stand”.
Make sure fuel connections are tight and that there are no fuel leaks.
Make sure fuel hose (5) lies flat on the ground and is not looped or kinked.
1
2
3
