TM 10-4520-263-12&P 0020 00 UNIT MAINTENANCE SPACE HEATER SMALL (SHS) NSN 4520-01-478-9207SPACE HEATER SMALL REPAIR 0020 00-1/(2 Blank) INITIAL SETUP:Tools Personnel Required General Mechanic Tool Kit (WP 0029 00, Table 2, Item 1)One Materials/Parts Equipment Condition SHS shut-down and cool (WP 0005 00)GENERAL This procedure is for dent removal on the following SHS items: rain cap assembly, stack assembly, canister lid assembly, and burner body. WARNING! Carbon Monoxide Bent or dented components may allow deadly carbon monoxide emissions into the operating space. Do not attempt to repair these components if leakage will not be completely stopped, or death may result due to inhalation of excessive amounts of carbon monoxide. REPAIR Use common tools (pliers, mallets, etc.) to remove, to the extent possible, any dents which impair operation of the heater. Dent removal should only be carried out on the burner body, canister lid assembly, rain cap, stack assembly sections, and the heat shield. Dent removal should be done short of replacing the item or items if and only if equipment operation will not be reduced. For example, if dent removal does not stop smoke leakage into the heated space, the faulty component or entire heater should then be replaced. END OF WORK PACKAGE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
