TM 10-7310-241-12&P 4-22.10     Change 1                                 4-16.1  REPLACING THE CONTROL PANEL ASSEMBLY FOR MODEL 471012 (Continued) NOTE The following procedure applies to either the green indicator light or the white indicator light.      (1)  Remove the control panel (Subparagraph 4-16.1a, steps (1) thru (4)).        (2)  Unsolder the two indicator light leads (1) from the circuit board (2).      (3)  Remove the spring plate (3) that secures the indicator light in place.      (4)  Remove the indicator light (1) from the control plate (4). m.  Installing the Indicator Lights. NOTE When installing the indicator light, ensure that the leads are correctly attached to the circuit board.  Touch up the soldered connections, on both sides of the circuit board with conformal coating.      (1)  Install the indicator light (1) on the control plate (4).      (2)  Install the spring plate (3) to secure the indicator light in place.      (3)  Solder the two indicator light leads (1) to the circuit board (2).      (4)  Install the control panel (Subparagraph 4-16.1ff, steps (1) thru (5)). n.  Inspecting the Receptacle.                (1)  Remove the control panel (Subparagraph 4-16.1a, steps (1) thru (4)).      (2)  Check the front and back of the receptacle (1) to determine if any of the pins are bent, broken or             shorted together. 1 2 3