TM 10-7310-241-12&P
4-14.2 Change 1
4-14.1. REPLACEMENT OF THE LATCH FOR MODEL 471012 (Continued)
a. Replacing the Latch.
(1) Remove the two screws (1), and lock washers (2) that secure each latch (3) to the main container (4).
(2) Remove the latch (3).
b. Installing the Latch.
(1) Install the latch (3).
(2) Install the two lock washers (2), and the two screws (1) to secure the latch (3) to the main container (4).
c. Adjusting the Latch.
CAUTION
Do not over tighten the latches - the lid seal or latch retaining lip can be
damaged. Do not adjust the latches so tightly that the latch retaining lip
on the lid is deformed.
(1) Adjust the length of each latch by turning the threaded clasp arm in the latch body.
(2) Adjust the latches so that the lid seals tightly against the HWR body, and so that each latch requires the
same effort to close.