TM 5-3895-377-13&P
4-102.
HEAT SHIELD AND COVER REPLACEMENT AND EXHAUST STACK
CLEANOUT (CONT).
(5)
Remove fourteen nuts (11), lock washers
(12), washers (13), panel (14), and gasket
(15) from exhaust stack (16). Discard
gasket and lock washers.
b.
Cleaning/lnspection.
WARNING
Protective
equipment
(gloves,
goggles, ventilation mask) must be
worn when cleaning exhaust stack.
Breathing exhaust waste can be
harmful to personnel.
(1)
Using a whisk broom, clean exhaust stack
(16).
(2)
Inspect parts for cracks, broken welds,
excessive wear, or damage.
c.
Installation.
(1)
Install gasket (15), panel (14), fourteen
washers (13), lock washers (12), and nuts
(11) on exhaust stack (16).
(2)
If removed, installed fourteen cage nuts
(10) on Heater (9).
(3)
Position two screws (3), lock washers (2),
and nuts (1) in left heat shield (4) and right
heat shield (5). Do not tighten nuts.
(4)
Install left heat shield (4) and right heat
shield (5) on heater (9) with fourteen
screws (6), lock washers (7), and washers
(8).
(5)
Tighten nuts (1).
NOTE
Follow-on Maintenance: Remove wheel
chocks (page 2-35).
END OF TASK
4-294
