TM 5-3895-377-13&P
Section III. OPERATOR’S MAINTENANCE PROCEDURES
3-4.
MAINTENANCE INTRODUCTION.
This section covers maintenance tasks authorized at the operator/crew level of maintenance. The tasks provided in this
section include maintenance tasks done on a scheduled basis (PMCS).
3-5.
HYDRAULIC MASTER CYLINDER SERVICE.
This task covers:
a.
Fluid Check
b.
Filling
INITIAL SETUP
Materials/Parts
Equipment Condition
Brake Fluid, (item 1, appendix E)
Wheels Chocked (page 2-17)
a.
Fluid Check.
(1)
Remove cap assembly (1) from master cylinder (2).
(2)
Check brake fluid level. Brake fluid level should be to the bottom threads of fill hole.
b.
Filling.
(1)
Fill master cylinder (2) with brake fluid (item 1, appendix E) to the bottom threads of fill hole.
(2)
Install cap assembly (1) on master cylinder (2). Tighten cap assembly.
NOTE
Follow-on Maintenance: Remove wheel chocks (page 2-35).
END OF TASK
3-5
