TM 5-3895-377-13&P
3-7.
WHEEL AND TIRE ASSEMBLY REPLACEMENT (CONT).
b.
Installation.
CAUTION
Ensure flanged end of nuts are against wheel. Failure to comply will result in damage to equipment.
NOTE
Nut should be snugged to ensure wheel is flush against hub.
(1)
With the aid of an assistant, install wheel
and tire (6) on studs (7) with nuts (4).
(2)
Lower screw jacks (2) by turning handles
(5) until tires touch ground.
(3)
Tighten eight nuts (4) in sequence shown.
(4)
Remove pins (1).
(5)
Position screw jacks (2) in stowed position
on upper mount (3).
(6)
Install pins (1).
(7)
Place sand pads in stowage box.
NOTE
Follow-on Maintenance: Remove wheel
chocks (page 2-35).
END OF TASK
3-8