O P E R A T O R / C R E W MAINTENANCE INSTRUCTIONS
Section I. LUBRICATION INSTRUCTIONS
to prevent an accumulation of foreign matter.
3-1 General
3-2 Lubricant Storage
For all lubrication instructions refer to L0 5-
Keep all lubricants in closes containers and store in
2805-256-12, Keep all external parts not
a clean, dry place away from external heat. Allow no
requiring lubrication clean of lubricants.
dust, dirt, or other foreign material to mix with the
Before lubricating the equipment, wipe all
lubricants. Keep all lubrication equipment clean
lubrication points free of dirt and grease.
and ready to use.
oclean all lubrication points after lubricating
Section II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
3-3 General
are taken will be recorded on DA Form 2404
(Equipment Inspection and Maintenance
Preventive maintenance services are minimum
Worksheet) as soon as possible.
inspections which are performed to insure that
defects may be discovered and corrected before
they result in serious damage to or failure of
the equipment. When defects are discovered
The preventive maintenance services listed in the
during operation of the equipment, they must
table are the minimum inspections to be performed
be corrected as soon as operation has ceased. If
by the operator on the heater with the Military stan-
continued operation would result in damage to
dard engine. The services will be performed in the
the equipment, the defects must be corrected at
sequence in which they are numbered:
once. All deficiencies and shortcomings that
are discovered and all corrective actions that
