TM 5-4520-244-14
REMARKS
ITEM
ACTION
LOCATION
INSPECTION
. Inspect all parts for serviceable condition. Replace any broken, damaged or
worn out parts with a serviceable like item. Inspect ignition plug for indication
of excessive heat damage.
INSTALL
4.
Install gasket (16)
Combustor
Use nuts (13)
and combustor (15)
assembly
and washers (14)
Screw plug (12)
Ignition plug
into plate (11)
ADJUST
Using the shank of a 5/32-inch drill bit, measure the spacing (gap) between the
ignition plug electrode (19) and the grounded electrode (20). Bend the grounded
electrode to the correct gap as indicated by the 5/32-inch drill bit shank.
INSTALL
Screw seal (10),
5.
Nozzle
a.
Strainer and
strainer (9) and
seal
components
nozzle (8) into
holder (7)
b.
Clamp (6)
Install nozzle holder
(7) into plate (11)
and clamp (6) on
plate (11) using
screws (5)
Combustor
Install plate assembly
c*
into combustor (15)
plate
by engaging tabs
assembly
6.
Install check valve
Check
(17) into adapter (18)
valve (17)
on line (1)
Screw fuel lines (1)
7.
Fuel
and (2) into nozzle
lines
holder (7)
8.
Screw cable (21) to
Ignition
cable
4-52