TM 5-4520-253-13
TEST PC BOARD ASSEMBLY (CONT)
5. Before testing PC board assembly, follow troubleshooting and maintenance/testing procedures for
component involved. Be sure fault is not in component or wiring to component.
6. Be sure control box harness is not faulty before testing circuits of control box components.
Refer to INSPECT CONTROL BOX WIRING HARNESS, page 3-45.
7. Disconnect unsoldered wires before testing.
TESTING:
1, Tests for PC board assembly are contained in table 4-3. Table has six columns providing infor-
mation necessary to perform each test, as follows:
a,
b.
c.
d.
e.
Column (1) - Component Circuit.
Identifies circuit to be tested.
Column (2) - Heater Mode. Describes condition of heater for testing named circuit.
Column (3) - Test For/Meter Setting.
Describes proper setting of volt ohmmeter.
Columns (4 and 5) - Probe No. 1 and probe No. 2. Explains where each probe is
Probe numbers are arbitrary. Either probe may be placed at either position.
placed.
Column (6) - Meter Indication. What meter will show if circuit is good. Failure to achieve
indication means circuit is faulty.
2. No repair to PC board is authorized.
If testing indicates faulty circuit, replace PC board
assembly.
4-27
