TM 9-2540-205-24&P
BLOWER ASSEMBLY - HUPP MF510B, MF510C, MF60A-24V, MF60B-24V - Continued
LOCATION
ITEM
ACTION
REMARKS
ASSEMBLY
28. support (1)
Motor (2)
29.
Duct (3) and shell (4)
30.
Four screw assemblies (5)
31.
Cable clamp (6), screw
assembly (7), and nut
assembly (8)
32. Motor (2)
33. Combustion blower
wheel (1 O)
34. Motor (2)
Combustion blower wheel (10)
Setscrew (11)
Ventilation blower wheel (12)
35. Ventilation blower wheel (12) Setscrew (13)
36. Resistor (14)
Clamp (15)
37. support (1)
Clamp (15) with
resistor (14)
38. Clamp (15) and support (1)
Screw assembly (16) and nut
assembly (17)
Note markings and place in
position.
a. APPLY sealant to each side.
b. Place in position.
Screw in and tighten.
a. Place clamp (6) around
lead (9).
b. Place clamp (6) in position.
c. Screw in and tighten.
a. Push on until setscrew(11)
is lined up with flat on shaft.
b. Pull off until wheel (10) turns
freely.
a. Rotate blower wheel (10) to
access setscrew (11 ).
b. Screw in and tighten.
a. Push on as far as possible
with flat lined up with
setscrew (13).
b. Pull off until wheel (12)
turns freely.
Screw in and tighten.
Install.
Install.
Screw in and tighten.
3-67
