BLOWER ASSEMBLY - HUPP MF510B, MF510C, MF60A-24V, MF60B-24V - Continued
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION
39. Combustion chamber (1)
40. Blower assembly (2) and
combustion chamber (1)
41.
42. Top cover (4)
43. Grommet (5)
44. Combustion chamber (1)
45.
46. Top cover (4) and bottom
cover (8)
47.
48.
49. Inlet cover (11) and
exhaust adapter (12)
50.
51. Duct (14)
Blower assembly (2)
Four screw assemblies (3)
Four screw assemblies (3)
and joint between blower
assembly (2) and combustion
chamber (1)
Three grommets (5)
Six leads (6)
Top cover (4)
Exhaust shield (7) and bottom
cover (8)
Two screw assemblies (9)
Six screw assemblies (1 O)
Inlet rover (11 ) and exhaust
adapter (12)
Eight screw assemblies (13)
NOTE
a. Apply sealant to inside of
rim.
b. Install.
Screw in and tighten.
Apply sealant,
Install.
Push through from bottom.
a. Press down into position.
b. Turn chamber (1) upside
down.
Install.
Screw in and tighten.
Screw in and tighten.
a. Install.
b. Aline all screw holes.
c. Push in.
Screw in and tighten.
Steps 50 and 51 only apply to MF510B.
Duct and elbow assembly (14)
install.
Two screw assemblies (15)
Screw in and tighten.
NOTE
Steps 52 through 54 only apply to MF51C, MF60A-24V, and MF60B-24V.
3-69
TM 9-2540-205-24&P
