BLOWER ASSEMBLY - STEWART-WARNER 10560M, 10560M24B1 - Continued
LOCATION
ITEM
ACTION
REMARKS
ASSEMBLY
26. Air housing (1)
27. Grommet (2) and
air housing (1)
28. Air housing (1)
29.
30. Motor (4)
31. Ventilation blower wheel (6)
32. Diode mounting
assembly (8)
33. Motor (4)
34.
35. Blower housing (14)
36. Motor subassembly (15)
37.
38. Motor subassembly (15)
39. Combustion blower
wheel (18)
Grommet (2)
Two leads (3)
Motor (4)
Four screw assemblies (5)
Ventilation blower wheel (6)
Setscrew (7)
Lead (9) and screw
assembly (10)
Two washers (11 ) and small
gaskets (12)
Large gasket (13)
Motor subassembly (15)
Two nut assemblies (16)
Two screw assemblies (17)
Combustion blower wheel (18)
Setscrew (19)
Install.
Install.
Install with long shaft of motor (4)
into air housing (1), noting position
marks made during disassembly.
Screw in and tighten.
Install with setscrew (7) in line with
flat side of shaft.
a. Rotate wheel (6) so setscrew
(7) is in line with slot in air
housing (1).
b. Tighten.
Outside edge of
ventilation blower
wheel must be flush
with outside edge of
alr housing.
a. Feed lead (8) through, and
install terminal.
b. Screw in and tighten.
Install.
Install.
a. Install, noting positions
marked during disassembly.
b. Lineup screw holes and slots.
Screw on and tighten.
Screw in and tighten.
Install with setscrew (19) in line
with flat side of shaft.
Tighten.
3-109
TM9-2540-205-24&P
