TM 9-2540-207-14&P
5.2.3
VENT FAN SHROUD
Figure 5-2.6. Vent Fan Shroud
Removal
!CAUTION!
When handling electronic circuits, personnel must be electrically grounded to
avoid electrostatic damage to electronic components. During the following
operations take care not to damage the electronic boards.
1.
Remove Vent Fan Assembly (ref. 5.2.1)
2.
Using a 1/4" socket or 1/4" nut driver, remove four (4) hex-head screws to detach the Dual Air Adapter. (ref.
Fig. 2-1)
Note: The Dual Air Adapter gasket should remain with the Dual Air Adapter. Use
Silicone RTV to re-attach, if required.
3.
Using a #2 cross-tip screwdriver, remove three (3) flat-head screws from the front face of the Vent Fan Shroud.
!CAUTION!
DO NOT set the Vent Fan Assembly down on the Magnet end of the Motor or the
Electronic circuit boards may be damaged.
5-15