TM 9-2540-207-14&P
5.2.1
VENT FAN ASSEMBLY
Figure 5-2.2. Vent Fan Assembly
Removal
!CAUTION!
When handling electronic circuits, personnel must be electrically grounded to
avoid electrostatic damage to electronic components. During the following
operations take care not to damage the electronic boards.
Note: It is NOT necessary to remove the Dual Air Adapter for this operation.
1.
Remove Top Shell (ref. 5.1.2)
2.
Remove Bottom Shell (ref. 5.1.3)
3.
Disconnect Power Wiring Harness connection J6 to the Vent Fan Driver Board
Note: Connector J6 is released by pressing the sides of the connector together
with your fingers releasing the locking tabs, and gently pulling apart the two
halves.
5-10
