TM 9-2540-207-14&P
5.1.3
Bottom Shell (continued)
Installation (continued)
Note: To allow alignment of Bottom Shell and screw holes, adjust the slider plate
found at the exhaust hole in the Bottom Shell.
Tip: Fit the Bottom Shell seams into the slots on each end of the Heater before
tightening the screws.
2.
Using a 1/4" nut driver or 1/4" socket, install three (3) self tapping screws.
3.
Install Top Shell (ref. 5.1.2)
5.1.4
IGNITER & IGNITE R HOLDER
Refer to Section 4.4.1
5-8