TM 9-2540-207-14&P
5.1.1
TOP COVER
Figure 5-1.2. Top Cover
Removal
1.
Use either a 1/4" nut driver, a 1/4" socket, or #2 flat blade screwdriver to remove four (4) #8-32 machine screws
and star washers.
2.
Gently pull top cover away from Top Housing.
Note: The Diagnostic Code Label is permanently attached with adhesive to the Top
Cover.
Installation
1.
Align the slot in the Top Cover with the fuel inlet valve in the Top Housing, and place the Top Cover onto the Top
Housing. Ensure the two sides of the Top Cover are kept inside the edges of the Top Shell.
2.
Use either a 1/4” nut driver, a 1/4" socket, or a #2 flat blade screwdriver to secure the Top Cover to the Top
Housing with four (4) #8-32 machine screws and star washers.
Note: Ensure that the Wiring Harness is properly tucked inside the Top Housing
and the Top Cover does not put pressure on any components or other wires.
5-4
