TM 9-2540-207-14&P
5.5.1
FUEL PRESSURE SENSOR
Figure 5-5.4. Fuel Pressure Sensor
Removal
1.
Remove Top Cover (ref. 5.1.1)
2.
Disconnect Fuel Pressure Sensor connector (J4) from the Logic Wiring Harness.
!CAUTION!
If the Fuel Pressure Sensor is dropped, it may be damaged and should be
replaced.
Note: The connector is released by pressing, lifting the locking tab, and gently
pulling apart the two halves.
3.
Using a 9/16" open ended wrench, remove Fuel Pressure Sensor from the Fuel Inlet manifold.
5-53
