TM 9-2540-207-14&P
5.5.1
Fuel Pressure Sensor (continued)
Installation
!CAUTION!
When replacing a Fuel Pressure Sensor, DO NOT remove the plastic protector cap
from the Fuel Pressure Sensor until ready to install.
!CAUTION!
DO NOT insert any objects into the Fuel Pressure Sensor.
1.
Apply Loctite 592 to the threads of the Fuel Pressure Sensor.
2.
Using a 9/16" open ended wrench, install Fuel Pressure Sensor into the Fuel Inlet manifold. When tight, the
wires of the sensor should be 180 degrees from the Fuel Inlet.
3.
Connect the Fuel Pressure Sensor connector (J4) to the Logic Wiring Harness.
4.
Start the Heater and check that there are NO fuel leaks from the fuel connections (ref. Figure 5-5.9)
5.
Install Top Cover (ref. 5.1.1)
5-54
