TM 9-4520-251-14
5-7 GOVERNOR (CONT)
Location/Item
Action
Remarks
REPAIR
2. Link and
Straighten bends in link (4) and lever (5).
lever
3.
Governor
Replace defective parts as needed.
lNSTALLATION/ADJUSTMENT
NOTE
Always use new crankcase gasket when installing crankcase cover.
4.
Governor
Refer to illustration and reassemble governor.
5. Lever
Be sure that spring (6) is connected to lever (5)
at second hole from the end and to bracket (7).
Loosen nut (8). Using screwdriver in slot in end
of crankshaft (17), rotate crank (14) clockwise
as far as it will go and hold while tightening nut (8).
Torque nut to 35 to 45 in. lb (4.0 to 5.0 Nm).
5-11