TM 9-4520-257-12&P 0005 00
0005 00-5
2. Remove the top heater shell (7) from the heater body base (1) by loosening the wing nuts
on the bolt and wing nut assemblies (8) and sliding the bolt and wing nut assemblies (8) out of the
brackets (9) on the top heater shell (7). Set the top heater shell (7) aside. If not already done,
remove all the components stored inside the heater. (See WP 0009 00 for an inventory of all the
components.)
3. Place the adapter ring (2) on top of the heater body base (1).
4. Insert the grate assembly (3) into the adapter ring (2), with the draw grate (4) on the bottom of the
assembly and the shaker catch (5) facing the grate heater door (6).
5. Place the top heater shell (7) on the heater body base (1). Slide the bolt and wing nut assemblies
into the brackets (9) on the top heater shell (7) and tighten the wing nuts.
7
1
9
8
2
3
5
4
6
PREPARING THE H-45 TYPE I (SOLID HEATER) FOR OPERATION
