TM 9-4520-257-12&P 0005 00
0005 00-33
3. Inside the tent, lift the stack assembly (14) from the stack flange (15) on the top heater shell (19).
Lower the stack cap (16) with attached guy lines (13) through the tent stack shield opening (17). Lay
the stack assembly (14) on the tent floor.
4. Remove the stack cap (16) with attached guy lines (13) from the topmost stack section. Stuff the guy
lines (13) inside the stack cap (16), and set it aside for storage inside the heater. Separate the six
stack sections, leaving the seams of the stack pipe sections sealed, and set them aside for storage or
transport. Close the flap on the tent stack shield opening (17). (Refer to the tent-specific operator
manual for closing the tent stack shield.)
5. Outside the tent, at the fuel supply site, unstrap the fuel can (1) from the fuel can stand (2), remove
the fuel can (1) from the fuel can stand (2), and place the fuel can (1) upright on the ground. To do
this, see the previous section in this work package entitled “Refueling The Type II (Liquid Fuel)
Heater,” steps 1 and 2.
NOTE
A piece of commercial petroleum absorbent material should be used to
catch any fuel that may spill while connecting or disconnecting any
hoses. Additional commercial products are available to contain large
spills.
In the event that fuel is spilled on the ground, immediate action must be
taken to contain the spill, and the appropriate environmental personnel
should be notified.
Clean up any spilled fuel with a rag. Dispose of the rag and/or absorbent
material in accordance with the local Material Safety Data Sheet (MSDS)
procedure.
6. Inside the tent, place a piece of commercial petroleum absorbent material under the end of the fuel
supply hose (3) that connects to the fuel flow control valve (4). Disconnect the fuel supply hose (3)
from the fuel flow control valve (4). To do this, pull back on the female QD fitting on the end of the
fuel supply hose (3), and remove it from the male QD fitting on the fuel flow control valve (4).
7. Disconnect the fuel overflow hose (11) from the fuel flow control valve (4). To do this, pull back on
the female QD fitting on the end of the fuel overflow hose (11), and remove it from the male QD fitting
on the fuel flow control valve (4).
8. Outside the tent, pull the fuel overflow hose (11) from under the tent wall, coil it, and set it aside for
storage inside the heater.
9. Outside the tent, pull the fuel supply hose (3) from under the tent wall. Drain any fuel remaining in the
fuel supply hose (3) by coiling the hose from the heater to the gravity feed adapter (5) while holding
the hose above the level of the fuel can (1). To do this, open the priming valve T-connector (6)
slightly to allow air to enter the hose and to allow the fuel to drain completely back into the fuel can.
