TM 9-4520-258-14
4-15. DUCT ASSEMBLY.
This task consists of: a. Removal
b. Inspection c. Cleaning
d. Repair
e. Installation
INITIAL SETUP:
Tools:
General Safety Requirements:
Tool Kit, General Mechanics (Item 1, App B)
WARNING
Equipment Condition:
Allow unit to cool down before attempting service/
Unit disconnected from power source (para 2-8)
inspection/maintenance activity.
Material/Parts:
Mild Soap (Item 10, App E)
Pressure Sensitive Tape (Item 14, App E)
Rags (Item 2, App E)
WARNING
Contact with hot components can cause burns. Allow unit to cool down before attempting
service/inspection/maintenance activity.
NOTE
Removal and installation is typical for both ducts.
a. Removal (Refer to Figure 4-9)
Loosen clamps (1) on both ends of duct (2) and remove from unit (3) and shelter connector.
Figure 4-9. Duct Assembly (Sheet 1 of 2)
4-57