TM 9-4520-258-14
4-17.
POWER CABLE ADAPTER CORD - continued.
Repair - continued (Refer to Figure 4-14)
NOTE
Hold connector plug while turning sleeve assembly to prevent twisting of conductor wires.
(12)
Hold connector plug (4) tight and slide sleeve (13) up cord (1) and screw sleeve (13) onto connector
plug (4).
(13)
Slide rubber bushing (12), grommet (11), grommet follower (10), and clamp (9) up cord (1) and screw
clamp (9) onto sleeve (13).
NOTE
The rubber bushing should bulge slightly when saddles are tight.
(14)
Position two saddles (8) on clamp (9), secure with two screws (6) and two nuts (7).
(15)
Insert strap (3) through end of chain on cover (5) and secure onto connector plug (4).
(16)
Screw cover (5) into connector plug (4).
(17)
Repair to other end of cable is limited to stripping of insulation to expose .25 inch of wire and tinting
each end.
Figure 4-14. Power Cable Adapter Cord Repair (Sheet 3 of 3)
4-69
