TM 9-4520-258-14
4-16.
REMOTE CONTROL THERMOSTAT - continued.
d.
Assembly (Refer to Figure 4-13)
(1)
Install connector (1) and nut (2).
(2)
Install wires (3), (4) and (5) through nut (6) and connector (1).
(3)
Connect wires (3), (4) and (5) to TB2 (7) with three screws (8) as follows:
(a)
Connect green wire (3) P3-C/TB2-1 to TB2-1.
(b)
Connect white wire (4) P3-A/TB2-2 to TB2-2.
(c)
Connect black wire (5) P3-B/TB2-3 to TB2-3.
NOTE
Flat edges of connector hex and nut must be parallel with the back edge of remote thermostat
box or cover will not seal properly.
(4)
Position cable (9) in connector (1) until the cable (9) insulation is flush with inside of connector (1)
and tighten nut (6).
(5)
Install cover (10), with notch at bottom, and four screws (11) on remote thermostat box (12).
Figure 4-13. Remote Control Thermostat Assembly
4-65
