TM 9-4520-271-14
0026 00
ASSEMBLY
Continued
MODE SWITCH S1 Installation
1.
Install jumpers (8) and all wires (6) with screws (7). Remove wire marker tags.
2.
Jumper locations are as follows:
Between S1-12 and S1-13
Between S1-13 and S1-14
Between S1-17 and S1-18
Between S1-22 and S1-23
Between S1-23 and S1-24
Between S1-21 and S1-31 (deck-to-deck)
Between S1-33 and S1-34
Between S1-13 and S1-14
Between S1-53 and S1-54
Between S1-57 and S1-58
WARNING
Acrylic lacquer sealant is flammable. Keep away from open flames or other sources of ignition. Avoid
breathing fumes from sealant. Good general ventilation is normally adequate. Avoid skin contact with
sealant.
3.
Apply light coat of acrylic lacquer sealer to all MODE SWITCH S1 (4) terminals.
4.
Install preformed packing (5) onto shaft of MODE SWITCH S1 (4).
5.
Install MODE SWITCH S1 (4) and four sealing screws (3).
6.
Install knob (2) and tighten setscrew (1).
0026 00-28
