TM 9-4520-272-14&P
0050 00
ELECTRODE AND NOZZLE GAP ADJUSTMENT TOOL TEMPLATE
The template below is provided in the event that the electrode and nozzle adjustment tool permanently
tethered to the heater inside the burner access door has been damaged or lost. It is preferable to reorder
the adjusting tool using information provided in the RPSTL portion of this TM or to fabricate the tool
locally using the engineering drawing provided in the rear matter section of this TM. If the paper template
is used, it should be printed on card stock to improve rigidity and reproduced at its actual size. Once
printed, verify that the tool has been reproduced correctly by measuring the distance between the points
identified below. The distance between the points indicated should be exactly 0.25 inches.
Cut template from
page following
outline
Distance from center line to
Distance from center line to
vertical portion of crosshair
vertical portion of crosshair
must be 0.25 inch
must be 0.25 inch
Center line
END OF WORK PACKAGE
2
0050 00-11/(12 Blank)
