TM 9-4540-202-12&P
2-3. ASSEMBLY AND PREPARATION FOR USE - Continued
b.
Setting Up The Heater.
(1)
Install burner in burner compartment with cast iron vaporizer plate facing up (Figure 2-2).
(2)
Assemble each section of smokestack using two split rivets per section.
(3)
Attach the four sections of the smokestack to the collar on the flue compartment.
CAUTION
Do not set the fuel tank on the heater until after heater Is Installed In the
corrugated can. To do so will cause the unbalanced heater to fall.
(4)
Place heater in corrugated can with heater hanger resting on rim of can wall and with wall between
mounting clamp and rear plate on heater (Figure 2-3).
(5)
Turn two locking screws in hanger clockwise until they are tight against mounting clamp and the heater is
secure in position.
(6)
Fill can with water to within 6 inches of the collar assembly.
(7)
Check that fuel tank is full of fuel.
(8)
Place fuel tank on heater by placing mounting sleeve on tank over square stud on heater mounting bracket
(Figure 2-3).
2-6
