TM 9-4931-381-14&P-2
F R A M E 4 9
Install Board Assembly:
doing any work.
NOTE
Read paragraph 2-4 on tagging and soldering wires before
1.
Line up board (1) on three support angles (2). Check numbers (3) on
board (1) to be sure they prefacing up.
2.
Screw in and tighten three machine screws (4) and flat washers (S) with screwdriver.
NOTE
If board was removed for accessorily, go to follow-on
maintenance and TASK 23 ENDS HERE.
3.
Solder wires (6) to terminals of board (1); refer to wiring chart.
GO TO FRAME 50
2-104
Volume IV
Para. 2-6, Task 23
