T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
F R A M E 7
Remove Leg:
NOTE
o
If removing front leg (1) attached to holding fixture
base (2) and bracket (3), do steps 1 through 3 for each
1.
2.
3.
leg removed.
o
If removing rear leg (4) attached only to base (2), do
steps 4 and 5 for each leg removed.
Unscrew and take out two machine screws (5), Iockwashers (6), and flat washers (7)
from bracket (3) with screwdriver. Get rld of Iockwashers (6).
Unscrew and take out two screws (8), Iockwashers (9), and washers (10) from
base (2) with screwdriver. Get rid of Iockwashers (9).
Take off leg (1). Look at leg (1) for stripped screw holes. If bad, turn in leg (1). If
OK, set aside for later use.
4. Unscrew and take out two machine screws (8), Iockwashers (9), and fIat washers (10)
from base (2) with screwdriver. Get rid of Iockwashers (9).
5. Take off leg (4). Look at leg (4) for stripped screw holes. If bad, turn in leg (4). If
OK, set aside for later use.
Follow-on Maintenance:
NOTE: To install leg, refer to task 8.
TASK 6 ENDS HERE
Volume IV
Para. 3-7, Task 6
3-43
