TM 9-4931-381-14&P-2
FRAME 13
Install Pin, Plate, and Assembly:
NOTE
Use this task to install either of two pins (1), revolving
plates (2), or spindle assembly (3).
1.
Put spindle assembly (3) through hole in riser assembly (4).
2. Line up hole in revolving plate (2) with hole in stationary plate (5) and put pin (1) in
hole in revolving plate (2).
3.
Put cap socket screw (6) through hole in pin (1) and screw in and tighten screw (6),
new Iockwasher (7), and flat washer (8) with key.
Follow-on Maintenance: None
END OF HOLDING FIXTURE ASSEMBLY MAINTENANCE
Volume IV
4-28
Para. 4-5, Task 11