D I R E C T SUPPORT AND GENERAL SUPPORT
MAINTENANCE
INSTRUCTIONS
Section I. REPAIR PARTS, SPEClAL TOOLS AND EQUIPMENT
maintenance described in this chapter. T h e
5-1. Repair Parts
common tools, however, that are used in field
T h e repair parts that
are authorized for use in the
maintenance and in depot maintenance of this
Direct Support and
General Support Maintenance
equipment are authorized in the appropriate table
of the heaters with
the MIL-STD model 1A08-3
o f o r g a n i z a t i o n a n d e q u i p m e n t or
table
of
engine are listed in
TM 5-2805-256-241'.
allowances.
5-2. Tools
T h e r e are no special tools authorized for use in the
Section II. TROUBLESHOOTING
5-3. General
Troubleshooting
Procedures
This section contains troubleshooting information
Malfunctions and troubleshooting procedures for
in tabular form to help in locating and correcting
t h e engine assembly are shown in TM 5-2805-256-
some of the malfunctions that may develop in the
14. Malfunctions and troubleshooting for the
heater.
heater are listed in table 5-1.
Section III. GENERAL MAINTENANCE
washers (7) from the heater handle brace brackets
Bracket, Braces, and Brace Brackets
(6). Remove the heater handle braces (5) and the
brackets (6) from the heater.
a. Removal.
b . Inspection. C h e c k t h e c o m p o n e n t s f o r d e n t s ,
bends, breaks, and cracks.
lockwashers (4) from the right heater handle
c. R e p a i r . S t r a i g h t e n b e n t h a n d l e s , b r a c k e t s ,
tiedown bracket (2) and take off the bracket.
and braces and weld any cracks or breaks.
R e m o v e the left heater handle tiedown bracket (9)
d. Installation. Reverse the procedure in
in the same manner.
a. a b o v e .
(2) Lift the handle (1) from the heater.
(3) Remove the screws (8) and the lock-
