TM 5-3895-377-13&P
4-42.
SIDE MARKER LIGHT REPLACEMENT (CONT).
(3)
Remove butt connector by cutting wires (5,
6, and 7). Discard butt connector.
(4)
Loosen nuts (8 and 9) and remove conduit
(10 and 11) from marker light (4).
(5)
Remove wires (5 and 7) from marker light
(4).
(6)
Remove two adapters (12) from marker
light (4).
(7)
Remove two nuts (13), screws (14), marker
light (4), and gasket (15) from Heater (16).
Discard gasket.
b.
Installation.
(1)
Install gasket (15) and marker light (4) with
two screws (14) and nuts (13) on Heater
(16).
(2)
Install two adapters (12) in marker light (4).
(3)
Install wires (5 and 7) in marker light (4).
(4)
Install conduit (10 and 11) on marker light
(4) and tighten nuts (8 and 9).
(5)
Connect wires (5, 6, and 7) with butt
connector.
(6)
Install lamp (3) in marker light (4).
(7)
Install preformed packing (2) and lens (1).
NOTE
Follow-on Maintenance: Remove wheel
chocks (page 2-35).
END OF TASK
4-90
