TM 5-3895-377-13&P
(3)
Remove butt connector by cutting wires (5,
6, 7, and 8). Discard butt connector.
(4)
Loosen nut (9) and remove conduit (10)
from marker light (4).
(5)
Remove wire (8) from marker light (4).
(6)
Remove adapter (11) from marker light (4).
(7)
Remove six nuts (12), screws (13), three
marker lights (4), and three gaskets (14)
from Heater (15).
(8)
Remove two connector modules (16) from
three marker lights (4) and wires (5 and 6).
b.
Installation.
(1)
Install two connector modules (16) on three
marker lights (4).
(2)
Feed wires (5 and 6) thru connector
modules (16).
(3)
Install gaskets (14) and marker lights (4) on
Heater (15) with six screw (13) and nuts
(12).
(4)
Install adapter (11) and wire (8) in marker
light (4).
(5)
Install conduit (10) with nut (9) on marker
light (4). Tighten nut.
(6)
Connect wires (5, 6, 7, and 8) with butt
connector.
4-87
