TM 5-4520-253-13
l N S P E C T / R E M O V E / l N S T A L L D A T A P L A T E S ( C O N T)
3. Install name plate by installing control box cover (1) as follows:
a.
b.
c.
d.
e.
f.
Thread wires of FAULT and HEAT lights (2 and 3) through mounting holes from front of
control box cover (1). Seat white light in mounting hole marked HEAT and red light in hole
marked FAULT.
Secure lights with barrel fasteners (6).
Install HEATER-OFF-FAN switch (14) through mounting hole from back of cover (1) and
secure at front of cover with hex nut (8).
Install harness clamp (15) around harness wires.
Install cover (1) on control box using three
screws (9), lock washers (10), and nuts (11). Use one combination screw/lock washer/nut to
secure harness clamp as illustrated.
Connect violet wire (5) and yellow wire (7) to leads of FAULT light (2). Connect white wire
(12) and orange wire (13) to leads of HEAT light (3). use new butt connectors (4).
If in doubt as to location of any wire, find wire number in table 3-5 and check From/To
columns.
3-83
