TM 5-4520-253-13
REPAIR PC BOARD ASSEMBLY WIRING RECEPTACLE (CONT)
9.
10.
11.
12.
13.
14.
15.
16.
Make potting rim (14) around receptacle (10) using tape.
Rim must project beyond receptacle
around wires (12) 1/4 inch ( 6 . 3 5 m m ) o r m o r e . -
Fill rim with MI L-A-46106 sealant and allow 8 hours
Install cable ties (11) to replace any removed.
to harden.
Install PC board wiring receptacle (20) from inside heater case. Push receptacle through
hole until locking tabs snap into place.
Plug control box harness (9) into receptacle.
Install right-hand louver panel (7) by locking eight studs (8).
mounting
Reach through heater case opening (6) and connect louver linkage to right-hand louver paneI (7).
Install bottom cover (5) using six screws (3) and lock washers (4).
Close control box cover (1) and lock stud (2).
4-23
