TM 5-4520-253-13
4.
REPAIR PC BOARD ASSEMBLY WIRING
5.
6.
TERMINALS (CONT)
Check female couplers (4) and terminal flag (5) for security, damage, and burning. Be sure terminal makes
firm contact with mating terminal. Replace loose, damaged, or poorly fitting terminals. If damaged terminal is
still firmly crimped to wire, cut wire close to terminal. Strip 3/8 inch (9.53 mm) of insulation and crimp on new
terminal.
Check receptacle (6) for loose wires. Check potting for security. Check receptacle sockets for signs of burn-
ing or other damage to male terminals (7). If receptacle is defective, refer to REPAIR PC BOARD ASSEM-
BLY WIRING RECEPTACLE, REPAIR, page 4-21, and replace.
For Model UH-68G1, check plug (8) for loose wires. Check potting for security. Check plug sockets for signs
of burning or other damage to female terminals (9). If plug is defective, refer to REPAIR PC BOARD ASSEM-
BLY HARNESS RECEPTACLE AND PLUG, page 4-26.2, and replace.
Change 2
4-25
