TM 9-2540-207-14&P
5.4.1
Heat Exchanger (continued)
Installation (continued)
9.
Using pliers, re-set the Secondary Air Duct with the 1" metal spring clamp so as to remove any kinks or bends in
the hose.
10.
Using a 7/16" open ended wrench, install the Exhaust Sensor. Snap the wide end of the Exhaust Sensor into the
locking clip located on the Heat Exchanger.
11.
Connect the Vent Sensor connector (J5) to the Wiring Harness. Ensure the locking tab is engaged.
12.
Insert Flame Tube (ref. 5.3.2)
13.
Install Combustor Assembly (ref. 5.3.1)
14.
Install Vent Fan Assembly (ref. 5.2.1)
15.
Install Bottom Shell (ref. 5.1.3)
16.
Install Top Shell (ref. 5.1.2)
17.
Install Top Cover (ref. 5.1.1)
5-47
