TM 9-4520-271-14
0026 00
DISASSEMBLY
Continued
Electromagnetic Interference (EMI) Jumper and Terminal Boards TB1, TB2, and TB3 Removal
NOTE
Procedures are typical for terminal boards TB1, TB2, and TB3 except that only terminal board TB1 has an
EMI jumper. Terminal board TB2 is shown.
1.
Open side rear door (1).
2.
Cut wire ties as required and tag all wires (2).
3.
Remove screws (3), wires (2), jumpers (4), and two EMI jumper (5) leads (terminal board TB1 only).
4.
Loosen two nuts (6), screw (7) and remove EMI jumper (5) (terminal board TB1 only).
5.
Remove two nuts (8), lockwashers (9), washers (10), screws (11), terminal board TB2 (12), and marker strip (13).
0026 00-10