T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
FRAME 1
Remove Pin, Plate, and Assembly:
1.
2.
3.
NOTE
Use this task to remove either of two pins (1),
revolving plates (2), or spindle assemblies (3). Only one
pin (1), revolving plate (2), and spindle assembly (3) are
shown.
Unscrew and take out cap socket screw (4), lockwasher (5), and flat washer (6) from
pin(l) with key. Get rid of lockwasher (5).
Pull out pin (1) and lift revolving plate (2) off of riser assembly (7). Pull
spindle assembly (3) out of riser assembly (7).
Look at pin (1), revolving plate (2), and spindle assembly (3) for cracks and bends. If
bad, turn in pin (1),revolving plate (2), or spindle assembly (3). If OK, set aside for
later use.
Follow-on Maintenance:
NOTE: To install pin, revolving plate, and spindle assembly, refer to
task 11.
TASK 1 ENDS HERE
Volume IV
4-6
Para. 4-5, Task 1
