TM 10-4500-200-13
STAND ASSEMBLY
1. FULLY EXTEND ALL 3 LEGS UNTIL THEY REACH
2. REMOVE LOWER END OF BRACES FROM THEIR
POSITIONS AND INSERT INTO REAR LEG.
CAN
MOUNTING
INSTRUCTIONS
1. PASS LEFT ARM OF STAND THRU CAN HANDLE, KEEPING THE
CAN FACING THE GROUND.
CAUTION: MAKE SURE ADAPTER GRAVITY FEED IS FULLY
SEATED TO AVOID LEAKING.
2. POSITION LEFT STRAP UNDER LEFT ARM AND ACROSS THE CAN
BODY.
3. POSITION RIGHT STRAP ACROSS CAN BODY, RUNNING DOWN
TOWARDS THE LEFT STRAP.
4. SECURE LEFT AND RIGHT STRAPS USING "D" RINGS.
Figure 2-8. Fuel Can Stand Assembly (Type II and Type I with Conversion Kit installed).
Change 15
