TM 9-4520-258-14
4-26. COMBUSTOR CONTROL RELAY (K1) ASSEMBLY.
This task consists of:
a.
Removal
b.
Disassembly
c.
Repair
d.
Assembly
e.
Installation
INITIAL SETUP: |
Tools:
Material/Parts:
Tool Box, General Mechanics (Item 1, App B)
Lockwasher (Item 15, App H)
Offset Phillips Screwdriver (Item 2, App B)
Terminal Splice -(Item 26, App H)
Repair Kit Electrical Connector (Item 2, App B)
Wire Tags (Item 9, App E)
Rags (Item 2, App E)
Equipment Condition:
Unit disconnected from power source (para 2-8)
General Safety Requirements:
WARNING
Contact with hot components can cause burns.
Allow unit to cool down before attempting
service/inspection/maintenance activity.
NOTE
Disassemble only to the level required to make repairs.
a.
Removal (Refer to Figure 4-37)
(1)
Open side, rear door (1).
(2)
Tag and separate four wires (2) at terminal splice (3). Discard splices. Remove screw (4) and clamp
(5).
(3) Tag and disconnect wires (6) and (7) from combustor relay (8).
4-112
