TM 9-4520-258-14
4-36. POWER CABLE ASSEMBLY.
This task consists of:
a. Removal
b. Inspection
c. Repair
d. Installation
INITIAL SETUP:
Tools:
Equipment Condition:
Tool Kit, General Mechanics (Item 1, App B)
Unit disconnected from power source (para 2-8)
Soldering Iron (Item 2, App B)
Tool Kit, Electrical Connector Repair (Item 2,
General Safety Requirements:
App B)
WARNING
Material/Parts:
Contact with hot components can cause burns.
Lockwasher (Item 9, App H)
Allow unit to cool down before attempting
Wire ties (Item 11, App E)
service/inspection/maintenance activity.
Wire tags (Item 9, App E)
WARNING
Contact with hot components can cause burns.
Allow unit to cool down before attempting
service/inspection/maintenance activity.
NOTE
Disassemble only to the level required to make repairs.
a.
Removal (Refer to Figure 4-74)
(1)
Open doors (1) and (2) on right side of unit (3).
(2)
Tag and disconnect wires (4), (5) and (6) from TB1 (7) as follows:
(a)
Remove black wire (4) P1-A from position TB1-1. Reconnect remaining wires.
(b)
Remove white wire (5) P1-B from position TB 1-2. Reconnect remaining wires.
(c)
Remove nut (8), lockwasher (9), flat washer (10), and green wire (6) P1-C from
ground post (11). Discard lockwasher. Reconnect remaining wires.
(3)
Remove wire ties (12) as required.
(4)
Loosen nut (13) on clamp (14) and feed cable (15) through clamp.
(5)
Loosen nut (16) and gently pull power cable (15) through fitting (17) from outside the unit.
4-174
