TM 9-4520-258-14
4-36. POWER CABLE ASSEMBLY - continued.
d.
Repair - continued (Refer to Figure 4-75)
NOTE
Hold connector plug while turning sleeve assembly to prevent twisting of conductor wires.
(12)
Hold connector plug (3) tight and slide sleeve (12) up cable (1) and screw sleeve (12) onto
connector plug (3).
(13)
Slide rubber bushing (11), grommet (10), grommet follower (9), and clamp (8) up cable (1)
and screw clamp (8) onto sleeve (12).
NOTE
The rubber bushing should bulge slightly when saddles are tight.
(14)
Position two saddles (7) on clamp (8), secure with two screws (5) and two nuts (6).
(15)
Insert strap (2) through end of chain on cover (4) and secure onto connector plug (3).
(16)
Screw cover (4) into connector plug (3).
(17)
Repair of other end of cable limited to replacement of terminal lugs (16).
Figure 4-75. Power Cable Repair (Sheet 3of 3)
4-179
