TM 9-4520-258-14
4-36. POWER CABLE ASSEMBLY - continued.
e.
Installation (Refer to Figure 4-76)
(1)
Insert power cable (1) through fitting (2).
(2)
Route power cable (1) along the bottom of unit, under combustor fan assembly (3).
(4)
Bring power cable (1) up along side the combustor fan assembly (3) and feed cable (1)
through clamp (4). Allow enough slack to attach the three wires to TB 1 (5) and G1 (6).
(5)
Connect wires (7), (8) and (9) as follows:
(a)
Connect green wire (7) P1-C, to the G1 (6), secure with flat washer (10), lockwasher
(11) and nut (12).
(b)
Connect white wire (8), P1-B to TB1 (5) position TB1-2.
(c)
Connect black wire (9), P1-A to TB1 (5) position TB1 1.
(6)
Tie power cable (1) to the wire bundle (13) using wire ties (14) as required.
(7)
Tighten nut (15) to secure clamp (4).
(8)
Tighten nut (16).
(9)
Close doors (17) and (18).
4-180
